Image unavailable Alfa Marine Spare Parts is an independent supplier and is not an authorized DEUTZ dealer. DEUTZ names and part numbers are used for identification purposes only.
Product image not available
Request a quote for this part.
DEUTZ Marine Parts
HARNESS CABLE TCD 2013 L06 4V
Availability: 2-7 days
Shipping: Worldwide
Price
On Request
Quote reference: Part No. 0421 5282
Need help identifying this part?HARNESS, CABLE TCD 2013 L06 4V #4
Product Details
Part Number
0421 5282
Description
HARNESS, CABLE TCD 2013 L06 4V #4
Brand
DEUTZ
Category
Others
Availability
2-7 days
Shipping
Worldwide
Price
On Request
Product Description
DEUTZ Wiring harness or electrical connection 0421 5282
1. Product Overview
DEUTZ Wiring harness or electrical connection 0421 5282 is listed under source title “HARNESS CABLE TCD 2013 L06 4V”. It is classified for Batch 6 as wiring harness or electrical connection within the electrical and electronic control system. The source title references TCD 2013, but that association has not been independently verified for Batch 6. Confirm the complete engine model, serial number, and arrangement before ordering.
2. Function and Operating Principle
A wiring harness or connection component organizes conductors and connectors so electrical power, sensor signals, and control commands can move between compatible engine components. Routing, connector keying, conductor capacity, shielding, and branch layout are application-specific.
The electrical path links controllers, sensors, actuators, and power-distribution points. Protective coverings, seals, locks, and supports help limit abrasion, vibration damage, moisture entry, heat exposure, and accidental strain at terminals.
3. Application Status
| Manufacturer / brand | DEUTZ |
|---|---|
| Part number | 0421 5282 |
| Component category | Wiring harness or electrical connection |
| System | Electrical and electronic control |
| Evidence level | C — Component identity only |
| Engine application | Source title references TCD 2013; verification required |
4. Typical Signs That Inspection May Be Required
| Observation | Possible significance |
|---|---|
| Intermittent electrical faults | May be associated with loose terminals, damaged conductors, or vibration-sensitive connections. |
| Chafed insulation or exposed wire | Can create short circuits, signal errors, or loss of continuity. |
| Corroded or heat-damaged connectors | May increase resistance or interrupt power and communication. |
| Repeated sensor faults | Wiring and connector checks are required before replacing the sensor or controller. |
These observations are inspection triggers rather than a confirmed diagnosis. Evaluate the complete engine system and follow the applicable manufacturer service information.
5. Inspection and Replacement Guidance
- Isolate electrical power using the approved procedure.
- Inspect routing, clamps, sleeving, terminals, seals, and connector locks.
- Check continuity and insulation only with approved diagnostic methods.
- Confirm branch layout and connector identification against the exact engine arrangement.
6. Information Required Before Ordering
- Complete engine or equipment model.
- Engine serial number and arrangement or configuration number.
- Installed part reference and clear photographs of the identification label.
- Installation position and related assembly information.
Compatibility notice: Verify 0421 5282 against serial-number-specific parts documentation before purchase or installation. Do not select the component by appearance or part-number similarity alone.